MoreExam
1. Question Content...
EXPLANATION
Answer: X - EXPLANATION Content.
Question1: Exhibit.Refer to the exhibit, which shows the output from the webfilter fortiguard cache dump and webfilter categories commands.Using the output, how can an administrator determine the category of the training.fortinet.com am website?
Question2: After enabling IPS you receive feedback about traffic being dropped.What could be the reason?
Question3: An administrator has configured two fortiGate devices for an HA cluster. While testing HA failover, the administrator notices that some of the switches in the network continue to send traffic to the former primary device What can the administrator do to fix this problem?
Question4: Which two statements about the Security fabric are true? (Choose two.)
Question5: Refer to the exhibit.which contains a partial configuration of the global system. What can you conclude from this output?
Question6: In which two ways does fortiManager function when it is deployed as a local FDS? (Choose two)
Question7: Exhibit.Refer to the exhibit, which contains the partial ADVPN configuration of a spoke.Which two parameters must you configure on the corresponding single hub? (Choose two.)
Question8: Refer to the exhibit, which contains a partial BGP combination.You want to configure a loopback as the OGP source.Which two parameters must you set in the BGP configuration? (Choose two)
Question9: Exhibit.Refer to the exhibit, which contains a partial policy configuration.Which setting must you configure to allow SSH?
Question10: Exhibit.Refer to the exhibit, which contains the partial interface configuration of two FortiGate devices.Which two conclusions can you draw from this con figuration? (Choose two)
Question11: Refer to the exhibit, which shows a network diagram.Which IPsec phase 2 configuration should you impalement so that only one remote site is connected at any time?
Question12: Which two statements about bfd are true? (Choose two)
Question13: Exhibit.Refer to the exhibit, which contains a CLI script configuration on fortiManager. An administrator configured the CLI script on FortiManager rut the script tailed to apply any changes to the managed device after being executed.What are two reasons why the script did not make any changes to the managed device? (Choose two)
Question14: Exhibit.Refer to the exhibit, which contains an ADVPN network diagram and a partial BGP con figuration Which two parameters Should you configure in config neighbor range? (Choose two.)
Question15: Exhibit.Refer to the exhibit, which contains an active-active toad balancing scenario.During the traffic flow the primary FortiGate forwards the SYN packet to the secondary FortiGate.What is the destination MAC address or addresses when packets are forwarded from the primary FortiGate to the secondary FortiGate?
